GIR!!!

[ccd00@aim.com]

i know there is already a gir penguin pattern on here but i wanted to do this one for my bf for christmas.
any size is good as long as its clear. 5-10 colors.
thanks in advance!

[Riibear]

I took a stab at this one. Its 11 colors and is 200 stitches by 204 stitches. Hopefully that isn't to big. I tried to make it smaller but it distorted the lettering to much when I did. Happy stitching

[StitchPlease]

Hope this works. Let me know if you want me to mess around with the lettering at all or change the size. On 14 ct. this will be 14 by 15 in. On 18 ct. this will be 11 by 12 in. On 22 ct this will be 9 by 10 in. It uses 7 colors.

EDIT: Sorry Riibear, didn't see you post!

[Riibear]

Hope this works. Let me know if you want me to mess around with the lettering at all or change the size. On 14 ct. this will be 14 by 15 in. On 18 ct. this will be 11 by 12 in. On 22 ct this will be 9 by 10 in. It uses 7 colors.

EDIT: Sorry Riibear, didn't see you post!

That's ok lol. This was the first pattern I had ever tried to make. I think you did a better job than I did anyway.

[StitchPlease]

Hope this works. Let me know if you want me to mess around with the lettering at all or change the size. On 14 ct. this will be 14 by 15 in. On 18 ct. this will be 11 by 12 in. On 22 ct this will be 9 by 10 in. It uses 7 colors.

EDIT: Sorry Riibear, didn't see you post!

That's ok lol. This was the first pattern I had ever tried to make. I think you did a better job than I did anyway.

Well I've only done a few patterns that weren't sprite based, and it's taken me a long time to get it to where I'm at. Every time I look at BlackMageHeart or Servotron I think that I'm just awful!

[ccd00@aim.com]

thanks!