triforce plastic carving
-
- Rank 4 - Raccoon Mario
- Posts: 123
- Joined: Mon Jun 01, 2009 2:03 pm
triforce plastic carving
check out this plastic carving I made in tech ed class
- Attachments
-
- triforce carving.docx
- (346.1 KiB) Downloaded 460 times
-
- Rank 9 - Hammer Mario
- Posts: 750
- Joined: Mon Jul 21, 2008 4:58 am
Re: triforce plastic carving
That's a nice carving in plastic.
http://jelibe-spritegirl.blogspot.com/ Visit my little crafty blog!!
-
- Rank 6 - Tanooki Mario
- Posts: 333
- Joined: Sat Apr 25, 2009 9:38 pm
- Contact:
Re: triforce plastic carving
very nice, what did you use to carve that?
-
- Rank 2 - Fire Mario
- Posts: 38
- Joined: Sat Apr 04, 2009 12:03 pm
Re: triforce plastic carving
Dang, that is really cool. Same question as above^
-
- Rank 4 - Raccoon Mario
- Posts: 123
- Joined: Mon Jun 01, 2009 2:03 pm
Re: triforce plastic carving
i used a dilling machine called a CNC router that was being used in my tech ed class
-
- Rank 9 - Hammer Mario
- Posts: 750
- Joined: Mon Jul 21, 2008 4:58 am
Re: triforce plastic carving
Are you in the class or teaching it?? Either way you deserve an A****
http://jelibe-spritegirl.blogspot.com/ Visit my little crafty blog!!
-
- Rank 6 - Tanooki Mario
- Posts: 333
- Joined: Sat Apr 25, 2009 9:38 pm
- Contact:
Re: triforce plastic carving
is that router machine really big and expensive looking or could i afford something like that?
-
- Rank 4 - Raccoon Mario
- Posts: 123
- Joined: Mon Jun 01, 2009 2:03 pm
Re: triforce plastic carving
The router is very large and expensive(unless you have a few thousand $ lying around for the machine, software, and plastic pieces)
Last edited by theBoz on Thu Nov 05, 2009 5:43 am, edited 1 time in total.
-
- Rank 6 - Tanooki Mario
- Posts: 333
- Joined: Sat Apr 25, 2009 9:38 pm
- Contact:
Re: triforce plastic carving
well i did just spend over $4000 on comic books this past month
-
- Rank 4 - Raccoon Mario
- Posts: 123
- Joined: Mon Jun 01, 2009 2:03 pm
Re: triforce plastic carving
even so, I wouldn't know where to get one