Sprite Stitch Board!

Ok, I made a few patterns and I am going to an anime convention this summer and would like to get them signed. I would like the details to stay intact, but I would like it if they could fit into an either 11 x 14 or 8 x 10 frame (whichever looks better, and has a sufficient amount of space for signing). The type of aida I have is 16 count.
Thanks for your help!

If you have already made the patterns what exactly is your request?

I want to make sure that the pattern will end up fitting in an 8x10 or 11x14 frame with enough space for the voice actor to sign it.

I don't have KG Chart so hopefully someone with that program can help you.
You should be able to calculate the size of the pattern yourself - it's simple math. Take the number of stitches of each dimension (length and width) and divide by the count of your fabric.

Well, for Haruhi, it says it's 52.61 cm by 52.61 cm, which comes out to be about 20 inches by 20 inches.. that's too big. I just need help 'shrinking' it to 11x14 size without losing detail and leaving enough space for them to sign. For Kamina it is 72.57 cm by 45.17 cm which is about 29 inches by 18 inches. and for Kyon it's 50.8 cm by 58.05 cm which is about 20 inches by 23 inches.

Are these ok? I have made them so that they would all fit inside a 11x14 inch frame. Let me know and I'll put up the KG Chart filee for you.

Yes! That is exactly what I was looking for. Thank you = ]

Here you go!

Thank you very much = ]

Servotron to the rescue! XD