Page 1 of 1

Tribal Companion Cube

Posted: Tue May 17, 2011 10:05 pm
by alamarana
Saw this pattern while looking around for Portal stuff.
It's pretty detailed and will probably be have to be big to get all the lettering legible, but if anyone can make this into a .sth file it would be very appreciated.
End size doesn't matter. I typically use 18 ct. Any suggestions are welcome.

Re: Tribal Companion Cube

Posted: Wed May 18, 2011 5:14 am
by MamaJMarie
The pattern say's its on 26 or 28 ct (don't remember which) but it'll be 500 stitches on whatever size you use, just bigger :) I hope this is about what you were looking for.
J :zelda
Companion_Cube_Tattoo.sth
(206.64 KiB) Downloaded 405 times

Re: Tribal Companion Cube

Posted: Tue May 24, 2011 10:36 pm
by alamarana
Thank you very much! I'll give it a shot. Not sure if the lettering will come out quite right, but at least I'll have the cube. Thank you again. :good:

Re: Tribal Companion Cube

Posted: Fri May 27, 2011 2:12 pm
by Miss_C
Could you make it into a .pdf? please? :grin:

Re: Tribal Companion Cube

Posted: Fri May 27, 2011 3:41 pm
by Pyper
You might be able to adapt the smaller lettering to backstitch and have it come out ok